With Mounting under the seat or on the side panel.
Perfect for any stock to performance application and absolutely brilliant to get an engine running when converting from injection to carburetor.
Compatible with stock crank sensor & coil.
Three control knobs allow 4 settings for each range; maximum advance, advance curves and rev-limiter in 5750, 6000, 6250 and 6500 RPM.
Not compatible with stock wiring harness.
Used on H-D engines to install an advanced, fully adjustable and dependable ignition system.
Super simple to set-up.
Adjustments can be done with engine off or running.
Custom motorcycles require nothing else than the Atmann ignition, and the bike will run.
No computer required.
Suitable to provide best timing for maximum power for all engine capacities and tuning levels, including stock.
Perfect idle at 900RPM or even at 350RPM, what ever your preference. Complete with instruction manual.
Dimensions are 6x7x3cm, smaller than a pack of cigarettes.
Made in Germany
Complete with instruction manual.
Note: Mikuni HSR carburetors are a very tight fit between M8 heads, Keihin carburetors will not fit.
Note: Manifolds are made from reinforced polyamide and require adequate support.
Fits:
2018 - 2024 Harley-Davidson Electra Glide Ultra Classic EFI FLHTCUI Milwaukee-Eight
2018 - 2024 Harley-Davidson Electra Glide Ultra Limited FLHTK Milwaukee-Eight
2018 - 2024 Harley-Davidson Electra Glide Ultra Limited Low FLHTKL Milwaukee-Eight
2018 - 2024 Harley-Davidson Road Glide Custom FLTRX Milwaukee-Eight
2018 - 2024 Harley-Davidson Road Glide Special FLTRXS Milwaukee-Eight
2018 - 2024 Harley-Davidson Road Glide Ultra FLTRU Milwaukee-Eight
2018 - 2024 Harley-Davidson Road King EFI FLHR Milwaukee-Eight
2018 - 2024 Harley-Davidson Road King Special FLHRXS Milwaukee-Eight
2018 - 2024 Harley-Davidson Street Glide EFI FLHX Milwaukee-Eight
2018 - 2024 Harley-Davidson Street Glide Special FLHXS Milwaukee-Eight
