Easy installation: replace the stock ECM, install the new lambda probes and new wiring, load the correct map for the bike and go New maps, software, firmware updates, map analysis and technical assistance available online for free It does not require calibration on a test bench Made in the U.S.A. Due to possible space issues, some aftermarket exhausts may require modifications or repositioning of the lambda probe bushing.
For Harley-Davidson XL 1200T Superlow,1200X Forty-Eight,1200C Custom,1200CX Roadster,1200V Seventy-Two,883L Superlow, 883N Iron,1200NS Iron 1200. Precision manufactured with a ceramic body made of stabilized zirconium dioxide, surface coated with gas-permeable platinum electrodes and a porous ceramic to help prevent erosion due to contamination and...
Precision manufactured with a ceramic body made of stabilized zirconium dioxide, surface coated with gas-permeable platinum electrodes and a porous ceramic to help prevent erosion due to contamination and particulates in the exhaust gases
For Harley-Davidson Dyna Fat Bob FXDF,Dyna Low Rider FXDL,Dyna Street Bob FXDB,Dyna Super Glide FXD,Dyna Super Glide Custom FXDC,Dyna Wide Glide FXDWG.Precision manufactured with a ceramic body made of stabilized zirconium dioxide, surface coated with gas-permeable platinum electrodes and a porous ceramic.
For Harley Davidson XL883N Iron,XL 1200C Custom,XL 1200X Forty Eight,XL 1200CX Roadster,XL 883L Superlow,XL 1200T Superlow.Precision manufactured with a ceramic body made of stabilized zirconium dioxide, surface coated with gas-permeable platinum electrodes and a porous ceramic to help prevent erosion due to contamination and particulates in the exhaust...
Precision manufactured with a ceramic body made of stabilized zirconium dioxide, surface coated with gas-permeable platinum electrodes and a porous ceramic to help prevent erosion due to contamination and particulates in the exhaust gases
This kit allows you to bypass OEM O2 sensors when upgrading from the stock exhaust system, without remapping the ECU.It fits the OEM front and rear sensor wiring harness on Harley-Davidson models from 2010 to 2022.
The active intake and exhaust system eliminator kit is used to avoid logging a diagnostic trouble code when installing some aftermarket air filters and exhaust systems that require the removal of active systems.
This O2 sensor eliminator is ideal for running your bike without O2 sensors.This allows you to simulate a cold sensor condition so that the ECM runs "open loop"
Used to reduce the oxygen sensor thread from 18 mm to 12 mm, allowing later HD models equipped with 12 mm O2 sensors to be compatible with earlier model exhausts with 18 mm sensors.
