Converts the standard front and rear turn signals of the bike with high visibility LED light
Smoked gray lenses.LED in white when turned off and amber when turned on
LED bulb with plug to be mounted directly in the OEM bulb socket
They are single-function (turn signal)
Resistors to adjust the LED flashing frequency are included
The kit includes:
four lenses
four LED lamp bulbs
four 50 W 6 Ohm LED load resistors
EU approved
-----------------------------
Extremely bright Amber / Yellow LED for internal indicator lights. Output: 600 lum | Lifespan: 30,000 hours Length: 1.96 "50mm; Diameter: 0.98" 25mm | Operating voltage: 9-30 V DC | Power: 3.6 watts
Each bulb has 33 high-power 2835 led chips, with ball protection cover with strong light penetration
Advantage: more than 300% brighter than the original halogen bulb, polarity design for easy plug and play installation, integrated in constant current IC for longer life and low power consumption.
----------------------------
Resistors will control current flow in electrical circuits, the best solution for "Bulb signal" / "OBC error message" after installing the SMD LED bulb
Slows down the flash frequency when switching from the bulb to the LED indicator, eliminates the need to replace the OE relay
Simple installation - Included with Quik 8PCS mounting clips, just connect the resistor in parallel to the LED light
Dimensions: ca. 4.9 x 2.2 x 1.5 cm (1.9 x 0.8 x 0.5 inches); Wire length: about 16cm (6.2 inches)
Universal mounting, simply swap with your vehicle's standard relay, this flasher relay controller will solve LED light flashing errors, no flashing, hyper flashing or OBC error messages
* Compatibility:
2009 - 2013 Harley-Davidson Road King Classic FLHRC
1999 - 2020 Harley-Davidson Road King EFI FLHR
2017 - 2020 Harley-Davidson Road King Special FLHRXS
